Saturday, May 21, 2016

How to Reset / Recover 7 Administrator with USB | For All Versions 7 / XP / Vista32 bit / 64 bit






First you have to make a bootable USB with this software to Reset

1. Download the file from the below Download Button and Extract it Must
Rar is www.2lets.com

2.Copy all the Extracted files onto ur USB (You do not need delete files alrdy on the USB drive.)
Do not copy the files in any folder orsub-directory, copy those files directly in USB

3. Open command prompt (Run as Administrator by right clicking on Command prompt)
Run this from a command line, like this:


j:\syslinux.exe -ma j:

replace j with the letter of your USB drive if it is on another
drive letter such as G , H etc.
After entering the command just wait for 10 seconds and then close the command prompt (your USB is rdy now)
On some drives, you may have to omit the -ma option if you
get an error.
Plse note that you may have to adjust settings in your computers BIOS
setup to boot from USB. To Boot from USB when your computer starts just press F12 rapidly until you 'll see boot menu. Then select the option Boot from USB and press enter.

Now the journey begins to reset your ;)
Once it boots successfully, it will display below screen :
You just need to pressEnter.





Then you 'll be shown the below containing the drives on your system followed by s like 1,2,3,4 etc. then you have to select the of your drive upon which you installed , mostly you install your on C drive so Just type 2 and press Enter.


The program will start to scan for the loion of the registry files.
It’s very uncommon that the registry is not inside the default folders, so it shouldn’t have any problem loing it.

When the process is finished, it will display the path and you 'll be shown below . Then Press “Enter” to continue.

The program will list the registry content and you 'll be shown the below . Then we 'llselect the option " reset [sam system security]"
So Type 1 and pressENTER

Then you 'll be shown below . Now we are going to select “Edit user data and s”.
Type 1 and press Enter :

It will show a list of the users that have been found on the system. as it is shown in below such as Administrator, HomeGroupUser$, Guest, User etc. So we have to write the exact name (capital and small letter keep in mind, such as if the user name is Ali then do not write ali )
In this case I will use the Administrator. As i have written below the green arrow and then press "Enter". Of course you can change other users as well.

Then you 'll be shown the below . Now we 'll select the option "Clr (blank) user " so Type“1″ (without the quotes) to clr the user :
You will see a message about " clred" will appr on your screen.

Do the following steps to make it permanent:
Step 1. Type “!”(without the quotes)& press Enter if you don’t want to clr more accounts.
Step 2. Type “q”(without the quotes)& press Enter, the program will ask you if there is something to save.
Step 3. Type “y”(without the quotes)& press Enter.


The utility then ask if you want to run it again. Type "no"(without the quotes)
and press “Ctrl + Alt + Del” to finish the process.
Now you can use that user account again.
I have tested it many times. Its 100 % Working. If you find any problem during any step then do no hesitate to comment in below section :)

No comments:

Post a Comment